Iteration_3

For the next phase I decided to experiment using the CNC Mill.

fullsizerender6

Using double sided tape to secure the foam to the platform.

fullsizerender5

Henry using the Computer to Properly align the machine to the X,Y,Z axis

fullsizerender4

Initial cuts on the foam

fullsizerender3 fullsizerender2

Because this particular piece of foam measured 15×15 I had to scale down my patterns to 7 5/8″.  To save time and material, we programmed the CNC mill to block out the portion with no pattern

fullsizerender_tree2

one hour and fifteen minutes later!

fullsizerender_8

Very happy with the end results of this pattern.

fullsizerender_tree

My second pattern is also successful with this one I played around with the elevations of the rings.

fullsizerender_star2

Pattern #3 wasn’t as successful as the others. I’m not sure what exactly went wrong, or what was over looked prior to beginning.

fullsizerender_star1

Not happy with the initials result of this pattern I went through my art supplies and found a drill bit.

img_0227

I used it to carve out the excess foam I didn’t want

img_0230

Although manually carving the foam is not as neat and clean like the CNC mill I’m much happier with this end result.

img_0231 img_0232

holding my patterns up against my lamp. I really like the transparency

This entry was posted in Enrique, Students FA2016. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *