How was the Project I? Did you enjoy it?
MECH4700 D570 Fluid Mechanics, Summer I 2019
Instructor: Professor Masato Nakamura
How was the Project I? Did you enjoy it?
The OpenLab is an open-source, digital platform designed to support teaching and learning at City Tech (New York City College of Technology), and to promote student and faculty engagement in the intellectual and social life of the college community.
It was okay. I found out later that some new instructions were different then the one in class. I hope I did it right. I did the best I could.
The project was interesting. I enjoyed doing the simulation.
Project I was pretty simple and interesting. I had a great time finishing it.
It was okay, one part was confusing which was the inputting the velocity.
it was ok. i believe you gave a little different parameters on friday because i read your post and i think it was a little different. i submitted through mailbox on friday.
It was ok. I think I did it incorrectly but I enjoyed doing it.
Project 1 was ok. I had a good time doing the simulation
It was okay and I enjoyed the simulation and getting the right velocity was the hard part.
Was good, new and challenging!!
Seemed pretty good. Came up with the design and followed the steps in the tutorial for the FloXpress.
The project was fine. I found it interesting how bad my design when the results were calculated and the velocities were shown. But besides that, I understood the simulation using the Floxpress
The project was fine. I found it interesting how bad my design when the results were calculated and the velocities were shown. But besides that, I understood the simulation using the Floxpress.
The project was pretty straight forward. The tutorial we did in class really helped to complete this project without any major issue.
It was a fun project. I enjoyed doing the simulation.
the project was fun, with the whole flo simulation and the assembly. it was quite an experience.