How was the discussion/lecture/ex today? It will be a bit difficult if you don’t have knowledge about strength of materials. Do you like it?
MECH2410 Machine Design Nakamura Spring2018
A City Tech OpenLab Course Site
How was the discussion/lecture/ex today? It will be a bit difficult if you don’t have knowledge about strength of materials. Do you like it?
The OpenLab is an open-source, digital platform designed to support teaching and learning at City Tech (New York City College of Technology), and to promote student and faculty engagement in the intellectual and social life of the college community.
I think the discussion on materials was ok. I think i just need to study it a bit more for me to understand it better
today’s discussion was alright it was a nice refresher of last semester.
Todays lecture wasn’t that hard, i understood pretty much all of it.
The lecture was ok, Just need to be refreshed all the material. This is a deeper look into the stress vs strain diagram that I was mainly familiar with.
The lecture was ok, Just need to be refreshed all the material. This is a deeper look into the stress vs strain diagram that I was mainly familiar with.
I think the discussion was good. Yes I like it.
the discussion was informative and covered the theory behind the formula. I remember most of the material because i took engineering materials last semester.
I think the discussion was good. Yes I like it.
Today’s class was good. I tookmy Strength and Materials classes over a year ago so I have to re-learn a lot of what we spoke about today.
The discussion was good. I just have to review a little bit of strength of materials and I think I’ll be fine
The lecture today was very clear and understandable. however, i will need to go over it again for better understanding in my own time. yes i like it so far.
it was little complicated but i think i can understand it a bit more if i study more.
The discussion and the lecture was okay. Just have to review all of my notes from the last semester to understand better. I would say average.
the discussion was ok. just need to know the right equation and plug in the right formula. and practice more.
Todays lecture was ok. I must study more of this topic and refer to samples.
The discussion was good enough. but i still have to review it to understand it lil better.
It was a good discussion to refresh my memory about the the stress-strain and also to know it can be applied to find the cold work factor.
it was a good lesson