Do you have any question about EX04 (tutorial #2)?
———————
Home > Discussion > DS05
-
Recent Posts
Recent Comments
Archives
Categories
Meta
DS05
This entry was posted in Uncategorized. Bookmark the permalink.
Department of Mechanical Engineering Technology and Industrial Design Technology
I could not complete ToolPath creation of Tutorial 02, yet.
No. It took a while but I completed it.
Seems to be working. I would like my work checked.
I am still working on the Toolpath creation. I ran into a problem and had to start over after Step 10.
I have problem in Quetion : What must be done in order to make transition from stem 12.7 to step 13. pg 102-103.
because there is no indication or order/commandabout pressing ok button for completion of step 12: 12.7. but I can begin step 13: It could not be pressed on Button “Backplot ” on “Operation Manager” Section.
No
I am getting familiar with the software and i am enjoying.
Thank You!
Very Wonderful!
Very Impressive!
Tutorial #3 was great, I did have issues with the finals steps.
No questions, thanks! 🙂
Did not finish the tutorial. If I have any questions will get back. Thanks.