Monthly Archives: November 2013

This Tuesday we finally moved to the final stage of our project – putting everything inside the bunny. We cut opened the rabbit by making a 3 inch hole under his front right foot, and then we took out half … Continue reading →

Last week I ordered an assortment of items; cables, switches, buttons, NPN transistors – most of the stuff needed to actually assemble our project, rather than just bare LED ribbons plugged into a breadboard. Unfortunately the stuff didn’t arrive until … Continue reading →

This week, The new battery for the quad rotor was ordered and we expect it to come in this upcoming week. We also measured the voltages that come out of each port of the quad rotor. We discovered that the … Continue reading →

  This week we’ve got a great enhancement for the project: John brought small LED lighting fixture and donated it to Hell Bunny. This fixture uses a whole bunch of red, green and blue super bright LEDs. They are three times … Continue reading →

This week our group focused mainly on design concepts for the blazer. The main question were, “Where should the LEDS be placed?” “Where should the mic placed?” The conclusion was the the LEDs will be place around the inner arm … Continue reading →

All the parts for our project have been laid out and have been ordered. Anything else we my need will hopefully be minor and can easily be purchased. I am currently trying to figure out the microphone placement. Also the … Continue reading →

This week we were able to get some of the measurements that we needed to continue with our project. We were able to get a reading of the power coming out of the board in the quad-rotor with a electrical … Continue reading →