Advice on a new design…

I was thinking of new ways to make both of the floors and the exterior skin relate to each other more and i came up with a new concept that eliminated the gap in the middle, extended the floors to meet all 4 edges, extruded the walls to meet the ceiling, and … it slanted the floors. I definitely ┬álike this version better than the other iterations. i just don’t know if you can slant the floors and i would like to know if this is permitted (Professor Clay). This is a rough rendering and i dont know if i should spend more time on this if its just going to be rejected by you but Please take a look.

ps: the first floor might look slanted but its not, it gives the illusion of it being slanted, only the second floor is slanted. floor height on the new is 27 feet max. the before one is 12 feet

also the slant is 4% … 6 degrees

Thanks!

AFTER; slanted walls…

rough-rendeing-2

v-ray-rendering-rough

rough-rendering

BEFORE; slanted walls (sladly.. still my main design and still in process)

foruth-image

 

Leave a Reply

Your email address will not be published. Required fields are marked *